In this section
To install
connector:
Refer to Section:
J1
2.5.1
J2
2.5.2
J3
2.5.3
J4 and J5
2.5.4
J6
2.5.6
J7
2.5.7
2.5.1 J1 Motor Connection
Introduction
The J1 motor cable connects the drive to the motor windings.
Motor cables are available from Pacific Scientific, or you can
make your own.
Note: Refer to Appendix C, “Series/Parallel Connections” for
additional information.
Mating
connector
The J1 motor connector is for a PCD 5-pin screw mating
connector. The mating connector, supplied with the unit, is type
ELFH05110.
Making your
own cable
If you need to build the cable, refer to the appropriate subsection
as follows:
To build the cable for
motor type:
Refer to Section:
4-lead
2.5.1.1
8-lead series
2.5.1.2
8-lead parallel
2.5.1.3
Pacific
Scientific cable
If the motor cable is purchased from Pacific Scientific, install as
follows. The Pacific Scientific order number is SPC-xxx , where
“xxx” is the length in one-foot increments up to 50 feet. For
example, SPC-050 is a cable 50 feet long.
2 - 10
5345/5445 Installation and Hardware Manual
Rev F
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
