Door Installation/Removal
Figure 18: Glass door and hooks.
Removal
1. Remove the decorative front and backing plate from the front of the fireplace, “Surround Installation/
Removal Instructions” on page 37. Take care to disconnect the wire on the left hand side of the backing
plate which attaches the switch to the interior of the fireplace.
2. There are two handles located on the fireplace door (Figure 18) which must be pulled inward toward the
center of the fireplace to unlock the door (Figure 19). This may take some effort because the door com-
pletes a tight seal around the firebox.
3. Remove the door and set aside.
Installation
1. Place the door over the opening of the fireplace.
2. There are two hooks on the top of the handles and two hooks on the bottom of the handle and so the door
must be placed squarely over the firebox opening.
3. Once the glass door is seated, close the door handles outward and inward until they stop.
4. The handle will not close completely. There will be an approximately 3/4” gap between the handles and
the door frame (Figure 20). This is normal.
5. Return the backing plate to its original position making sure to reconnect the switch wire to the backing
plate. Return the surround to its original position.
Figure 19: Unlocking the glass door.
Approx. 3/4”
gap
Figure 20: Door handles in closed position.
Figure 21: Locking the glass door.
15
5055.990-A
130717-44
i30 TOFINO
