Pilot location
Place extra vermiculite
here to hide gaps in
base pieces
Figure 74: Vermiculite surrounding pilot.
Air gaps
Figure 75: Air gaps.
Tip of 2nd log resting
on top of spacer
Figure 76: 2nd log on top of support.
Figure 77: 3rd log position.
9. Distribute a thin layer of vermiculite (about 1/4”) onto the front burner tray (Figure 74). Place extra vermic-
ulite over the small gaps between the front base piece and the two side base pieces. Keep the vermiculite
from interfering with the pilot assembly. Place a layer of vermiculite (about 1/4”) onto the rear burner tray
to fill it up until it is level with the side and end walls. Keep the vermiculite from falling into the air gaps
between the front and rear burners and the gap between the rear burner and the air deflector which
supports the first log (Figure 75).
10. Place log number two (Figure 56) so that the post protruding from the bottom of the log can be inserted
into the hole of the left base piece. Then position the front of the log so that it rests on top of the spacer
(Figure 76). The log and the vermiculite should ideally hide the spacer.
11. Place log number three (Figure 57) so that the post protruding from the bottom of the log can be inserted
into the hole of the left-hand base piece. Then position the front of the log so that it rests on top of the
front base piece (Figure 77). The front of the log should be very close, or just touching the front base
piece.
31
5055.990-A
130717-44
i30 TOFINO
