Oxford Instruments Mercury iTC, Handbook

Page: 91 / 146

Handbook
November 2011 / 59-UMC0071 / Issue 01
Mercury iTC
Page 91
BASIC OPERATING INSTRUCTIONS
Original Instructions
9 Tap Apply to save the changes.
10 To enable the interface, see Section 6.5.5 .
6.5.2 Configuring the RS232 serial interface (if required)
1 Tap Settings on the Home page.
2 Scroll to the RS232 tab.
3 Enter the required baud rate.
NOTE: If replacing a legacy unit, set the baud rate to 9600.
4 Set the required number of data bits.
5 Set the required parity scheme.
6 Set the required number of stop bits.
7 Set the required flow control scheme.
8 If ISOBUS is to be used, scroll to the ISOBus tab.
9 Set the ISOBUS address to a value between 1 and 8.
10 Tap Apply .
11 To enable the interface, see Section 6.5.5 .
6.5.3 Configuring the GPIB (if required)
1 Tap Settings on the Home page.
2 Scroll to the GPIB tab.
3 Enter a GPIB address value between 0 and 31.
NOTE: Every unit connected to the GPIB must have a different GPIB address.
4 Tap Apply .
5 To enable the interface, see Section 6.5.5 .
6.5.4 Configuring the USB interface (if required)
No configuration is required for the USB interface.
To enable the interface, see Section 6.5.5 .
6.5.5 Enabling remote control of the iTC
1 Tap Settings on the Home page.
2 Tap the Remote Access field and select an interface from the drop-down menu.
3 Tap Apply to enable the selected interface.