Handbook
November 2011
/
59-UMC0071
/
Issue
01
Mercury
iTC
Page 80
GETTING STARTED
Original Instructions
5.4
Powering up the unit for the first time
5.4.1
Setting the date and time
1
Switch the <
1 0
> switch on the rear panel of the unit so that the
1
is depressed.
1
Press the <
Power
> button on the front of the unit. The button illuminates blue.
2
Wait until the Home page appears (see
).
Figure 5-1
Home page
3
Tap
Settings
on the Home page. The General Settings page is displayed (see
4
Scroll the tabs until the Clock tab is displayed.
5
Tap
Clock
. The Clock Settings tab is displayed (see
).
6
Check the date and time that are displayed.
7
To change the date or time:
a) Select the parameter to be changed (e.g. Hour).
b) Enter a positive or negative offset value and tap
Apply
to save the change.
c) Repeat steps
to
until the displayed time is correct.
Example: The currently set time is 11:31. The correct time is 9:27. Enter an offset of
minus two hours and four minutes to set the clock correctly.
8
If the unit has already been configured for your application, continue from section
9
If the unit has not been configured for your application, continue from