OWC Jupiter Mini-SAS
SySteM Setup
6. Install the front rails first making sure the
bottom of the rail lines up with the bottom of
the designated rack units. Using
Figure 2.1e
as a guide secure the rail using two of the
included M5 pan head screws.
7. before securing the rear rail extension to
the back of your rack, make sure to slide the
extension into the rail as seen in
Figure 2.1f
.
8. secure the rear rail extension to your rack use
two of the included M5 pan head screws as
seen in
Figure 2.1g
.
9. after securing the rear rail extension to your rack,
secure the rail extension to the rail using two of
the included M5 pan head screws as shown in
Figure 2.1h
.
10. after repeating the steps for the other side,
you can now move on to installing the
Jupiter storage system into the rack as found
in section
2.2 Unit Rack Installation and
Removal
on the next page.
Figure 2.1e
Figure 2.1g
Figure 2.1h
Figure 2.1f
8
