OWC Jupiter Mini-SAS
SySteM Setup
2.1 RAIL INSTALLATION
The Jupiter expander Rack 835 storage system comes with rack mount slide rails attached to the sides of the unit
and the necessary screws and cage nuts for installing into 4-post square-hole rack systems. To install the slide rail
brackets into your rack, do the following:
1. The Jupiter expander Rack 835 requires two
rack units of space, take note of which units
on your rack that you will install Jupiter into.
2. Install the included cage nuts into your rack
using
Figure 2.1a
as a guide for cage nut
placement within the 2U's that have been
designated for Jupiter.
3. on the Jupiter unit, remove the securing
screw from the rail on the left and right sides
as seen in
Figure 2.1b
.
4. once the securing screws have been
removed, remove the rail arm from the Jupiter
unit by sliding it toward the rear of the unit as
seen in
Figure 2.1c
. When the rail arm stops,
push the release tab while continuing to slide
the rail arm off. after removing the rails, set
them aside taking note of the side from which
they were removed.
5. Remove the rail arm extensions from the
accessories box and match them to the
rails. Use
Figure 2.1d
as a guide for proper
matching of rails and the extension pieces.
sYsTeM seTUP
Front Placement
Rear Placement
Figure 2.1a
Figure 2.1d
Right Rail
Left Rail
Extension
Left Rail
Shorter gap
Shorter gap
Right Rail
Extension
Figure 2.1b
Securing screw
Figure 2.1c
Push to release
Slide
7
