USER'S MANUAL
General instructions for use
(Rev. 0)
I-Max Touch (110-120V)
81
6.8.1
Preparation of the device
To select the CEPH examination, press key "Examination Mode Selection"
(10) until the following message and graphic is displayed:
x x k V x x m A 4 . 5 0 s
C E 1 8 x 2 2 L L n 8 . 5
x = value defined by the settings
1.
Press the "Patient Entrance" (6) key ; the display will show
alternatively the following messages:
C
E
P
H
- R
E
M O
V
E
C
H
I N
R
E
S
T
and
C E P H - C L O S E
T E M P L E S U P P O R T
The first message tells the operator to remove the chin support, while
the second message tells him to close the temple clasps. These
operations are necessary to prevent interference with the rays beam
and with the panoramic sensor holder when the arm is being
positioned.
WARNING:
Neither of the two messages are controlled by the system and they can
therefore appear even if the unit has been set correctly, until the "Patient
Entrance" (6) key is pressed.
WARNING:
There is no need to position any type of chin support for the
cephalometric examination. The chin support used for panoramic
examinations must be removed as indicated on the display. If the chin
support is not removed, it will collide with the sensor holder during
alignment and can obscure some anatomical parts of the patient during
the examination.
At the same time, the temple clasps must be closed, in order to avoid
collision with the rotating arm.
Summary of Contents for I-Max Touch
Page 1: ...Version 25 September 2009 Rev 0 I Max Touch 0459 110 120V version User s Manual...
Page 5: ...USER S MANUAL Contents I Max Touch 110 120V Rev 0 iv THIS PAGE IS INTENTIONALLY LEFT BLANK...
Page 129: ...USER S MANUAL Maintenance I Max Touch 110 120V Rev 0 124 THIS PAGE IS INTENTIONALLY LEFT BLANK...
