Owandy Radiology Ow-RX, User Manual

Page: 62 / 74

USER MANUAL
System use
Ow-RX
(Rev. 6)
56
8.7 Exposure with the wireless X-ray button (optional)
It is possible to make an exposure using the wireless X-ray button.
Proceed as follows:
1.
Press and release the wireless X-ray button. The green LED will turn
on, indicating that the communication with the timer was successful.
2.
Move away the desired distance (no greater than 5m), in the opposite
direction of the X-ray beam.
3.
Press the X-ray emission button and hold it down during the entire
exposure.
The procedure continues as described in paragraph 8.6, points 4, 5
and 6.
4.
At the end of exposure, the green LED on wireless button flashes
quickly two times.
In the following table are described the different wireless X-ray button
green LED status.
Description
Flashing
frequence
Duration Action
Ready to exposure Fixed Fixed --
Wireless button
communication failure
High 2 seconds
Check that the device is
not switched off or in
sleeping/cooling mode.
If the device is active,
perform matching
procedure (see paragraph
8.7.2)
Matching procedure
failed
High 10 flashes Repeat matching
procedure (see paragraph
8.7.2)
Matching procedure OK Low 10 flashes --
Low battery Very high 2 sequences
of 5 flashes
Replace battery (see
paragraph 8.7.1)
Very low battery Very high 4 sequences
of 5 flashes
Replace battery (see
paragraph 8.7.1)
Wireless button faulty LED off -- Contact the technical
support