NEO S-Series Library Service Manual
Replacing Parts
10400666-005
©2015-20 Overland-Tandberg
32
4.
Secure the chassis to the rack with the
captive screws
on both side flanges.
5.
After the appliance is secured in the rack, verify that all
drives
are secure in their bays
and have not become unseated.
Reinstall the Tape Magazines
1.
Supporting the magazine underneath, position the
magazine rails
onto the alignment
rails in the appropriate bay.
2.
Using the handle, push the
magazine
slowly into the library until the magazine release
latch snaps into place.
The magazine automatically locks into place when it is correctly installed.
3.
remaining magazines
.
Reconnect Cables and Verify Firmware Version
1.
Reconnect
all the
cables
to the same ports from which they were removed.
2.
Reattach the
power cords
.
3.
Press the Base Module
power button
for one to two seconds to power on the library.
The
green LED
is shown when the library completes its Power-on Self-test (POST).
Package Chassis for Shipment
WARNING:
It is recommended that a mechanical lifter (or at least two people) be used during
rack installation or removal to prevent injury.
WARNUNG:
Um Verletzungen zu vermeiden, empfehlen wir zur Rack-Installation oder -
Deinstallation die Nutzung einer mechanischen Hebehilfe (oder mindestens zwei Personen).
AVERTISSEMENT:
Pour éviter toute blessure il est recommande qu'un monte-charge (ou deux personnes
au moins) soit utilisé lors de l'installation ou de l'enlèvement du support.
CAUTION:
Before transport the library, it is recommended that the shipping lock and the yellow
label is replaced from the rear panel on the top cover of the library.
