10400666-005
©2015-20 Overland-Tandberg
11
1
Overview
Possible Tools Needed
•
#2 Phillips screwdriver – securing or removing the round-hole rack adapter bracket,
securing retention inserts in square-hole racks.
•
Small Flat Head screwdriver or Torx tool – retracting the locking screen when moving a
library cover, using the magazine manual release.
•
T10 Torx tool – removing drive bay covers.
•
Small Flat Head screwdriver – removing a magazine access door.
•
Clip Nut installation tool – inserting or removing clip nuts in square-hole racks while
installing or removing rack rails.
Electrostatic Discharge
To prevent damaging the system, be aware of the precautions you need to follow when setting
up the system or handling parts. A discharge of static electricity from a finger or other
conductor may damage system boards or other static-sensitive devices. This type of damage
may reduce the life expectancy of the device.
To prevent electrostatic damage, observe the following precautions:
•
Avoid hand contact by transporting and storing products in static-safe containers.
•
Keep electrostatic-sensitive parts in their containers until they arrive at static-free
workstations.
•
Place parts on a grounded surface before removing them from their containers.
•
Avoid touching pins, leads, or circuitry.
•
Always be properly grounded when touching a static-sensitive component or assembly.
See the next section.
Grounding Methods
There are several methods for grounding. Use one or more of the following methods when
handling or installing electrostatic-sensitive parts:
•
Use a wrist strap connected by a ground cord to a grounded workstation or computer
chassis. Wrist straps are flexible straps with a minimum of 1 megohm (± 10 percent)
resistance in the ground cords. To provide proper ground, wear the strap snug against
the skin.
•
Use heel straps, toe straps, or boot straps at standing workstations. Wear the straps on
both feet when standing on conductive floors or dissipating floor mats.
•
Use conductive field service tools.
