OutBack Power EnergyCell 1100RE, Installation Manual And Owner'S Manual

Page: 25 / 70

PowerSafe DDm
Publication No. US-DDm-IM-003 Page 15
November 2003 www.enersysinc.com
Terminal Bars
Terminal bars are supplied with the battery
system to provide a cell terminal-to-terminal
plate connection.
1. Inspect the system to be assured that all
cells are connected correctly – POSITIVE to
NEGATIVE and according to the
ASSEMBLY DRAWING .
2. Clean the terminal bar contact area with a
stiff-bristle nonmetallic brush/pad until the
lead-plated surface is bright. Be careful not
to remove the lead plating with excessive
brushing.
3. Apply a light coat of heated NO-OX-ID
grease to the terminal bar contact area with
a small paintbrush.
4. Install terminal bar as shown in Figure 26.
5. Torque bolts to 88 in-lbs.
6. Apply a light coat of heated NO-OX-ID
grease to the bolted connections with a
small paintbrush.
INSTALL TERMINAL BARS
FIGURE 26