OutBack Power EnergyCell 1100RE, Installation Manual And Owner'S Manual

Page: 17 / 70

PowerSafe DDm
Publication No. US-DDm-IM-003 Page 7
November 2003 www.enersysinc.com
FRAME ASSEMBLY AND
INSTALLATION
To assemble and install the frame for the
PowerSafe DDm battery system, follow the
procedure below using the system layout
determined in the “System Layout” section.
Base Beams
1. LEVEL with customer-supplied floor shims,
and anchor in place. Do NOT torque
anchor bolts until frame assembly is
complete.
2. Install ALL base beams before continuing.
Vertical Channels
1. Insert vertical channels into base beams.
See Figure 9.
2. Bolt vertical channels to base beams. Refer
to below list for hardware order and Figure
10:
•
Serrated Hex Bolt (M10x1.5 –
100mm),
•
Rack Frame,
•
External Tooth Washer,
•
Flat Washer,
•
Lock Washer,
•
Hex Nut
3. Torque all connections (except anchor bolts)
to 40 ft-lbs.
INSTALL VERTICALS
FIGURE 9
VERTICAL CHANNEL TO BASE
BEAM HARDWARE DETAIL
FIGURE 10