ORTEC Easy-MCS, Hardware User Manual

Page: 119 / 132

931054C / 1213 APPENDIX D. COMMANDS AND RESPONSES
109
ENABLE_ACLEAR
Enables the AutoClr function of the Easy-MCS. When enabled, any data in memory is
replaced with the new data on the first pass, then additional passes are summed as in sum
mode. This is the replace-then-sum mode. See also ENABLE_ACLEAR, SHOW_ACLEAR,
and ENABLE_SUMMATION.
ENABLE_DISCRIMINATOR
Enables Discriminator input and disables the SCA input. See also DISABLE_DISCRIMI-
NATOR and SHOW_DISCRIMINATOR.
ENABLE_DWELL_EXTERNAL
Enables External Channel Advance signal and disables the internal dwell time clock. See also
DISABLE_DWELL_EXTERNAL and SHOW_DWELL. This command is invalid when
acquisition is in progress.
ENABLE_SUMMATION
Places the MCS in sum mode. In sum mode new data is summed with the old data when a scan
is made. In replace mode, new data replaces the old data when a new scan is made. See also
SHOW_SUMMATION, DISABLE_SUMMATION, DISABLE_ACLEAR, and ENABLE_
ACLEAR.
ENABLE_TRIGGER
Enables External Start signal and disables internal starting of passes. See also DISABLE_
TRIGGER and SHOW_TRIGGER. This command is invalid when acquisition is in progress.
INITIALIZE
Simulates a power-down/power-up cycle with loss of battery-backed-up memory. Sets the
MCS as though the following commands had been issued, and also resets all internal
hardware.
STOP
CLEAR_DATA
CLEAR_COUNTERS
DISABLE_DWELL_EXTERNAL
DISABLE_TRIGGER
ENABLE_DISCRIMINATOR
ENABLE_SUMMATION
ENABLE_ACLEAR
SET_DISCRIMINATOR 1.4
SET_DISCRIMINATOR_LEADING
SET_DWELL_ETHLD 1.4
SET_DWELL 1E
!
7