9
Step 7: Connect the EV weld head to the welder using the RJ-11 cable
Plug the RJ-11 jack
from the cable
chain wire harness
into the “Acc . Port”
on the back of the
welder then to the
port on the weld
head that reads “to
welder” .
Step 8: Plug in the weld head power cord
The weld head has a power cord coming out of the cable chain wire harness . Connect this to an electrical
outlet .
Step 9: Install the electrode in the nose cap
Remove the nose cap from the weld head and twist the electrode holder counter clockwise to open the
collet . Insert the electrode into the collet . Tighten the electrode holder clockwise to secure the electrode in
place . The electrode should protrude about a half inch out of the holder . Now replace the nose cap .
