25
Chapter 6: Welding with Computer
Step 1:
To use the Janome with a PC computer, it must be connected through
a local area network (LAN) . First, hook up the Ethernet RJ45 cable from
your network or router . The second step requires us to find the IP
address of the Janome . This can be found in two different ways: (1) by
using the hand held pendant, or (2) by looking at the list of connected
devices on your LAN or router . Contact your IT department for help
looking up the IP on the LAN or router . Otherwise, follow the next
steps to find the IP address using the pendant .
Step 2:
Using the pendant to finding the IP address:
Connect the pendant to the TPU port on the front of the Janome .
If not already done, plug in the AC power cord to the back of the Janome, and power it using the power
switch .
Step 3:
Next, press the “ESC” button a few time to make sure the pendant is on the home screen . Next, press
the “MODE” button, scroll down and highlight “Administration” and then press “ENTR .” Highlight
“Administrative Settings Mode” and press “ENTR .”
Step 4:
Next, scroll down and highlight “Ethernet Settings” and press “ENTR .” The IP address should be listed .
Write this down as you will need to enter it into the PC computer . If the IP address doesn’t look right, make
sure the robot has been plugged into a LAN that has a router or gateway . Contact your IT department with
any issues or questions .
