Installation
17
▐
2. Install the driver by securing it with four bolts (M4, not supplied)
through the four mounting holes provided. Leave no gap between
the driver and plate.
M4
(not supplied)
Be sure to use the supplied screws when securing the driver
mounting brackets.
z
Mounting to DIN rail
Use a DIN rail 35 mm (1.38 in.) wide to mount the driver.
1. Attach the DIN rail mounting plate (model number:
PADP01
) to
the back of the driver using the screws supplied with the plate.
Tightening torque: 0.3 to 0.4 N·m (42 to 56 oz-in)
DIN rail
mounting plate
Mounting screws
(M3, supplied)
•
Do not use the mounting holes (M3, three locations) for
the DIN rail mounting plate provided in the back of the
driver for any purpose other than securing the DIN rail
mounting plate.
•
Be sure to use the supplied screws when securing the DIN
rail mounting plate.
2. Pull the DIN lever down, engage the upper hooks of the DIN rail
mounting plate over the DIN rail, and push the DIN lever until it
locks in place.
DIN rail
DIN lever
Tab
3. Affix both sides of the driver using end plates.
End plates are not supplied.
End plate
z
Removing from DIN rail
Pull the DIN lever down until it locks using a flat blade-parallel tip type
screwdriver, and lift the bottom of the driver to remove it from the rail.
DIN lever
Use force of about 10 to 20 N (2.2 to 4.5 lb.) to pull the DIN lever to
lock it. Excessive force may damage the DIN lever.
