Detecting and Managing Faults
33
Related Information
■
“Indicator State Values” on page 33
■
“Indicator State Conditions” on page 33
Indicator State Values
This table lists typical values and acceptable ranges for the indicator targets. The
indicator targets report the state of the chassis status LEDs. You use this table in
conjunction with the value you recorded in
“Display Oracle ILOM Sensor Status” on
page 18
. If your indicator target’s value is outside of the acceptable range, refer to
“Indicator State Conditions” on page 33
.
Related Information
■
“Evaluate an Indicator State” on page 32
■
“Indicator State Conditions” on page 33
Indicator State Conditions
Three primary LED indicators provide management controller status, general chassis
status, and identification. The table correlates the indicator target with the LED that
represents that target.
When the locator LED is on, it is actually flashing. If the gateway is installed into a
relatively dense rack, the flashing action makes the gateway more conspicuous for
identification.
Indicator Target
Typical Value
Acceptable Value
/SYS/I_LOCATOR
Off
On
or
Off
/SYS/I_ATTENTION
Off
Off
/SYS/I_POWER
On
On
Indicator Sensor Target
LED
/SYS/I_LOCATOR
Locator
/SYS/I_ATTENTION
Attention
/SYS/I_POWER
OK
