Oracle SPARC T8-1, Service Manual

Page: 25 / 168

Identify Disabled Components
Identify Disabled Components
You can run the
show disabled
command from the Oracle ILOM prompt to identify
components that have been disabled either intentionally, by a user, or automatically, because of
a fault.
1.
At the Oracle ILOM prompt, type:
-> show disabled
Target | Property | Value
-----------------------------------+----------------+--------------------
...
/SYS/MB/CM0/CMP | disable_reason | Configuration Rules
...
2.
For additional information about a disabled component, type the
show -t
command and the Oracle ILOM target.
See “Component Names Displayed by Diagnostic Software” on page 26 .
For example:
-> show -t /SYS/MB/CM/CMP/BOB21/CH1/DIMM
Target | Property | Value
-----------------------------------+------------------------+------------
...
/SYS/MB/CM/CMP/BOB21/CH1/DIMM | type | DIMM
/SYS/MB/CM/CMP/BOB21/CH1/DIMM | ipmi name | P0/M3/B0/C1/D0
/SYS/MB/CM/CMP/BOB21/CH1/DIMM | requested_config_state | Enabled
/SYS/MB/CM/CMP/BOB21/CH1/DIMM | current_config_state | Enabled
/SYS/MB/CM/CMP/BOB21/CH1/DIMM | disable_reason | Configuration Rules
/SYS/MB/CM/CMP/BOB21/CH1/DIMM | fru_name | 8192MB DDR4 SDRAM DIMM
...
Related Information
■
“Log In to Oracle ILOM (Service)” on page 22
■
“Identify Faulted Components” on page 23
■
“Component Names Displayed by Diagnostic Software” on page 26
Detecting and Managing Faults 25