Oracle SPARC T8-1, Service Manual

Page: 125 / 168

Install the SPM
version that supports this chassis.
Note -
Whenever you replace the SPM or the motherboard, update the firmware on the server so
the portions of firmware in the two components remain consistent.
6.
Configure the NET MGT port so that it can access the network, and log in to the
SPM through the NET MGT port.
Refer to “Configuring SP and Host Network Addresses” in SPARC T8 Series Servers
Administration Guide , or the Oracle ILOM documentation for network configuration
instructions.
7. Download the system firmware.
Follow the firmware download instructions in “Updating the System Firmware” in SPARC T8
Series Servers Administration Guide , or the Oracle ILOM documentation.
Note -
You can load any supported system firmware version, including the firmware version
that was installed prior to replacing the SPM.
8. If you created a backup of your Oracle ILOM configuration, use the Oracle ILOM
restore utility to restore the configuration of the replacement SPM.
Refer to the Oracle ILOM documentation for instructions.
9. Power on the server.
See “Power On the Server (Oracle ILOM)” on page 159 or “Power On the Server (System
Power Button)” on page 160 .
10.
If TPM was initialized on the replaced SPM, complete these steps:
a.
Reinitialize TPM and reset the
tpmadm failover
command if it was previously
in use.
For information about initializing TPM using the Oracle ILOM interface to enable failover,
see Securing Systems and Attached Devices in Oracle Solaris 11.3 .
b. Restore the TPM data and keys that were backed up to the new SP you
install.
For information about migrating or restoring TPM data and keys, see Securing Systems
and Attached Devices in Oracle Solaris 11.3 .
11.
Verify the SPM.
See “Verify the SPM” on page 126 .
Servicing the SPM 125