Version 1.1.8 - 2021-7-29
106
Translation of original instructions
MB4P
ǀ
MB4PV
EN
MB4P_
M
B4PV
_GB
_5.
fm
5
Maintenance
In this chapter you will find important information about
Inspection
Maintenance
Repair
of the drilling-milling machine
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for
operational safety,
failure-free operation,
long service life of the drilling-milling machine and
the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
5.1
Safety
WARNING!
The consequences of incorrect maintenance and repair work may include:
Very serious injury to personnel working on the,
Damage to the drilling-milling machine.
Only qualified personnel should carry out maintenance and repair work on the drilling-
milling machine.
5.1.1
Preparation
WARNING!
Only carry out work on the drilling-milling machine if it has been disconnected from the
mains power supply.
"Switching-off and securing the drilling-milling machine“ on page 75
Attach a warning sign.
5.1.2
Restarting
Before restarting, run a safety check.
WARNING!
Before starting the drilling-milling machine, you must check that there is no danger for
persons and that the drilling-milling machine is not damaged.
5.2
Inspection and maintenance
The type and level of wear depends to a large extent on the individual usage and operating
conditions. Any indicated intervals therefore are only valid for the corresponding approved con-
ditions.
