Version 1.1.8 - 2021-7-29
74
Translation of original instructions
MB4P
ǀ
MB4PV
EN
MB4P_
M
B4PV
_GB
_1.
fm
1.9.3
Separating protective equipment
Adjust the protective equipment to the
correct height before you start working.
To do so, detach the clamping screw,
adjust the required height and re-tighten
the clamping screw.
A switch is integrated in the fixture of the
spindle protection which monitors that the
cover is closed.
INFORMATION
You cannot start the machine if the spindle
protection is not closed.
Img.1-2:
Separating
protective equipment
1.10
Safety check
Check the drilling-milling machine in regular intervals.
Check all safety devices
before each operation,
once a week (with the machine in operation),
after all maintenance and repair work.
General check
Equipment
Check
OK
Protective covers
Mounted, firmly bolted and not damaged
Signs,
Markers
Installed and legible
Functional check
Equipment
Check
OK
EMERGENCY STOP impact
switch
When the EMERGENCY STOP push button is activated, the drilling-
milling machine must switch off. Make sure that it is only possible to
restart the machine if the EMERGENCY STOP push button is unlocked
and the ON switch was activated.
Separating safety device
around the drilling and mill-
ing spindle
The drilling-milling machine may switch on only when the safety device
is closed.
