Keratron
®
Scout Installation and Operating Manual
OPTIKON 2000
6.3 INSTALLATION PROCEDURE
6.3.1 CONFIGURATION ON THE SLIT LAMP
Fig.1 – Diagram of the Slit Lamp configuration
To set up this configuration:
1. Insert the expandable pin of the Slit Lamp Adapter (4) completely in the
hole for accessories of your Slit Lamp and then turn its wheel in the
direction indicated with “TIGHT”, i.e.: in the clockwise direction. This
operation will make the pin to expand so to have a stable coupling.
Caution: avoid expanding the pin when it is not completely the hole,
in order not to stress its expander.
.I
2. Insert one of the two ends of the Slit Lamp Cable (1a) under the VK (1)
care to
plug it in the direction that the two dots do match
, and to insert
it perpendicularly until the latch clicks.
3. Insert the VK in the slit lamp adapter (take care that it is properly inserted
in its slot (not just leaned nor sideway) until the two sphere pins will
eventually click.
.I
4. While the Docking Base is turned off, insert the other end of the Slit Lamp
Cable having care to
plug it in the direction that the two dots do match
,
and to insert it perpendicularly until the latch will click.
Cod. 161204EN
6-2
2008-12-03 Rev.B