Keratron
™
Onda Installation and operating manual
OPTIKON 2000
Cod. 161401EN
7-1
2015-03-27
Rev.C
7
USING THE KERATRON
™
ONDA
7.1
INITIAL SCREEN
The Keratron
™ Onda is turned on by placing the power switch (1 in Figure5-1) in
the “I” position. After a few seconds the user will see the screen shown below in
Figure 7-1, and at the same time an automatic procedure will be initiated to check
the motors (“Motor Diagnosis”).
Figure 7-1: Keratron
™
Onda initial screen
It shows in an intuitive manner n
ot only all of the instrument’s measurement
functions, but also the configuration and accessories functions (Settings) and the
topography calibration functions (Calibration).
The
touch-screen
allows you to select the desired function by touching the screen
using the provided plastic
touch-pen
or another pen with a rounded plastic tip,
specifically designed for use with
touchscreens
.
NOTE: the use of another type of pen or instrument could irreversibly damage the
touchscreen
.
If the “Motor Diagnosis” procedure is not completed successfully, a warning
message will appear superimposed on the initial window (Figure 7-2) and the
operator can repeat the test.
