55
Power
– used for the battery charger. The charger also doubles as a mains connector. The
Charge status light is green when the unit is fully charged. It is red when it is charging and not
fully charged. The OS1p only charges when the unit is turned off.
Reset hole
– By inserting a pin or paper clip, the system can be rebooted if the system should
lock up.
Charge Status Light
– The light turns green when the Nickel Metal Hydride battery is fully
charged. It will be red when it is not, and yellow when it is partially charged. It only turns on
when the OS1p is turned off and the unit is plugged in. If the light is flashing, check the
charger connection. Make sure that it is properly inserted and the wall outlet is working. If
there is still a problem contact OSI
Right Side Panel
:
Figure 2-3
•
OS1p right side panel
Accessory port
– connection for PAR clip.
Fiber-optic light guide connectors
– male connectors for the tree randomized fiber optic
bundle connectors. Any of the fiber optic female connectors may be attached to any of the
right side panel connectors.
Remote Connector
– This is used for the trigger switch wire connector attached to the fiber
optic bundle, and it is used to trigger measurements from a button on the other end of the fiber
optic bundle.
