Opel 1900 1973, Service Manual

Page: 84 / 625

INSTRUMENT PANEL
Figure Removing Instrument Cluster Assembly
1 H-l
6 Disconnecting
Radio Wires
14. antenna lead-in at right lower corner
of radio!
15. Pull’ cluster housing out and turn sideways to
remove instrument gauge or switches.
I
Fasteners in subparagraph are impor-
tant attaching parts in that they affect the
of vital components and systems, and-
/or result in major repair expense. They must
be with one of the same part number, or
with an equivalent part if replacement becomes
Do not use a replacement part of lesser
quality substitute design. Torque values must be
used as during reassembly to assure proper
of these parts.
Plug antenna lead-in cable and power source to
radio.
2. Put cluster in position and replace six
(6) in cluster.
3. Connect speedometer
4. Raise steering column into position and install hex
head
Be sure to install ground wire. Tighten
hex head bolts to 14 lb.ft.
5. Tighten tear lock bolts until hex head of bolt is
torn off.
6. Connect ignition and directional signal wire set
plugs.
7. Install flasher unit.
8. Replace screws in right and left lower instrument
panel and replace both access covers.
9. Connect battery cable.
Removal of Combined Switch Assemblies. GT
1. Remove instrument cluster.
2. Turn instrument cluster to the side to remove
switch assembly.
3. Remove switch by removing two retaining nuts.
See Figure
4. Remove wiring from switch.
Figure 1 H-l 7 Removing Switches
Installation
1. Plug wiring into switch.
2. Install switch on panel.
3. Install instrument cluster.