Opel 1900 1973, Service Manual

Page: 460 / 625

AUTOMATIC TRANSMISSION 99
Converter Housing Oil Seal
With transmission on portable jack and converter
removed, converter housing oil seal may be removed
without disassembling transmission using tool
23129, and slide hammer J-7004.
2. Using tool J-23129 remove oil seal with slide ham-
mer.
3. Install new oil seal using installer J-21359.
Removal of Oil Pan
This operation can be performed with transmission
in vehicle.
1. Remove the twelve oil pan attaching bolts.
2. Remove oil pan and gasket. See Figure
Figure
Figure
REMOVAL OF VALVE BODY
8 Removal of Valve Body
This operation can be performed with transmission
in vehicle
1. Remove the manual detent roller and spring, re-
tained by two bolts. See Figure
2. Remove the three attaching bolts holding the
strainer assembly to the valve body and remove. Dis-
card gasket.
3. Remove the eight bolts from transfer plate rein-
forcement and remove reinforcement. See Figure
111.
Figure 11
4. Remove the four servo cover attaching bolts and
remove servo cover and gasket. See Figure
5. Remove remaining eight bolts attaching valve
body to case. Carefully remove valve body with gas-
ket and transfer plate. See Figure
Care must be taken so that manual valve and manual
valve link “A” are not damaged or lost during re-
moval of valve body from the case.