Onkyo TX-NR545, Manual

Page: 98 / 298

mode, where only the essential circuit is operating.
This setting is fixed to "Off" if "Bluetooth" ­ "Auto Input Change" is
set to "Off".
Wait for a while if "Network Standby" or "Bluetooth Wakeup" cannot be
selected. It will appear when the network function is started up.
Network
Make the network setting.
When LAN is configured with a DHCP, set "DHCP" to "Enable" to
configure the setting automatically. ("Enable" is set by default) To assign
fixed IP addresses to each components, you must set "DHCP" to
"Disable" and assign an address to this unit in "IP Address" as well as set
information related to your LAN, such as Subnet Mask and Gateway.
Wi­Fi
Default Value: Off (Wired)
Connect the unit to network via wireless LAN router.
"On": Wireless LAN connection
"Off (Wired)": Wired LAN connection
Wi­Fi Setup
Default Value: –
You can configure wireless LAN settings by pressing ENTER when
"Start" is displayed.
Wi­Fi Status
Default Value: –
The information of the connected access point will be displayed.
"SSID": SSID of the connected access point.
"Signal": Signal strength of the connected access point.
"Status": Status of the connected access point.
MAC Address
Default Value: –
This is the MAC address of the AV receiver.
This value is specific to the component and cannot be changed.
DHCP
Default Value: Enable