Onkyo TX-NR545, Manual

Page: 189 / 298

Others
Strange noises can be heard from the unit
If you have connected another unit to the same wall outlet as this unit,
this noise may be an effect from the other unit. If the symptoms improve
by unplugging the power cord of the other unit, use different wall outlets
for this unit and the other unit.
When performing Automatic Speaker Setup, the measurement fails and
the message "Ambient noise is too high." is displayed.
This can be caused by a malfunction in your speaker unit. Check if the
unit produces normal sounds.
The Late Night function does not work
Make sure the source material is Dolby Digital, Dolby Digital Plus or
Dolby TrueHD.
The Cinema Filter function does not work
This function can be used in the following listening modes: Dolby Digital,
Dolby Digital Plus, Dolby TrueHD, Multichannel, DTS, DTS­ES, DTS
Neo:6 Cinema, DTS 96/24, DTS­HD High Resolution Audio, DTS­HD
Master Audio, DTS Express, DSD.
How do I change the language of a multiplex source
Select "Main" or "Sub" for "3. Audio Adjust" ­ "Multiplex/Mono" ­ "Multiplex
Input Channel".
Cannot connect to the AV receiver from a Web browser
Make sure that the IP address of the AV receiver is correctly input to the
Internet browser.
When DHCP is used for allocating the IP address, the IP address of this
AV receiver may have been changed.
Make sure that both AV receiver and PC are properly connected to the
network.
Power consumption in standby mode
In the following cases, the power consumption in standby mode may
reach up to a maximum of 4.4 W:
– When "Network Standby" in "6. Hardware" ­ "Power Management" ­
"Network" is set to "On".
– When "HDMI CEC (RIHD)" is set to "On". (Depending on the TV
Troubleshooting