Onkyo TX-NR545, Manual

Page: 81 / 298

Select the crossover frequency from "40Hz" to "200Hz" to start
outputting frequencies for each channel.
"Full Band": Full band will be output.
"Full Band" can be selected only when "Front" is set to "Full Band".
If an item cannot be selected even though connection is correct,
check that the settings in "Configuration" ­ "Speaker Channels"
matches the number of connected channels.
Surround
Default Value: 100 Hz
Select the crossover frequency from "40Hz" to "200Hz" to start
outputting frequencies for each channel.
"Full Band": Full band will be output.
"Full Band" can be selected only when "Front" is set to "Full Band".
If an item cannot be selected even though connection is correct,
check that the settings in "Configuration" ­ "Speaker Channels"
matches the number of connected channels.
Back
Default Value: 100 Hz
Select the crossover frequency from "40Hz" to "200Hz" to start
outputting frequencies for each channel.
"Full Band": Full band will be output.
This cannot be selected in the following conditions.
– The setting for "Configuration" ­ "Bi­Amp" is "Yes"
– "Configuration" ­ "Powered Zone 2" is set to "Yes" and ZONE 2 is
on
"Full Band" can be selected only when "Surround" is set to "Full
Band".
If an item cannot be selected even though connection is correct,
check that the settings in "Configuration" ­ "Speaker Channels"
matches the number of connected channels.
LPF of LFE
Default Value: 120Hz
Set the low­pass filter for LFE (low­frequency effect) signals in order to
pass lower frequency signals than the set value and thus cancel
unwanted noises. The low­pass filter will be effective only on sources
with LFE channel.
The value from "80Hz" to "120Hz" can be set.
"Off": Do not use this function
Double Bass
Default Value: On