ONEUW ONE160x, User Manual

Page: 35 / 54

SINGLE-STROBE AND MULTI-STROBE SET-UP
14.2 Setting the ONE160's SLAVE mode
The ONE160's SLAVE mode is activated by the right INPUT control
selector on the strobe.
Pressing it for a long time the SLAVE mode is activated and it is
signaled by the light up of both the SYN and SLV indicators light. By
pressing the selector a beeping sound will be issued after about two
seconds. After the beeping sound the INPUT control selector can be
released.
At the first set-up, or new one not memorized, the first strobe you
switch-on must always to be set as SLAVE unit, the second (or last) one
as MASTER unit.
If you want to reverse the set-up of two strobes already switched on,
for example A = MASTER B = SLAVE, first set the unit A as the new
SLAVE and then the unit B as the new MASTER.
Respecting these sequences, the camera will always be interfaced with
only a MASTER unit, as required by i-TTL protocol.
Otherwise, if two MASTER units are recognized by the camera, the
digital data communication will be discontinued creating anomalies in
the functioning of both strobes.
30