SINGLE-STROBE AND MULTI-STROBE SET-UP
14.4 Canon cameras
Canon's TTL digital protocol provides for signal transmission by 6-pin
cables.
E-TTL auto exposure mode is supported by single strobe or a unit pair
connected by synchro cable to digital camera.
To operate in E-TTL mode, the housing must be equipped with six-pin
S6 connections.
Single-Strobe set-up
§
Single S6 socket with all 6 wires connected
ONE160x
Selectable mode: E-TTL or manual
Dual-Strobe set-up
§
1st S6 socket
(on the left or right)
with all 6 wires connected
ONE160x
Selectable mode: E-TTL or manual
§
2nd S6 socket
(on the left or right)
with all 6 wires connected
ONE160x
Selectable mode: E-TTL or manual
If NikonosV connections are used only manual mode is available and
only 2 wires must be connected (X trigger and GND ground).
33
Summary of Contents for ONE160x
