ONEUW ONE160x, User Manual

Page: 25 / 54

CONTROLS FUNCTIONS - DISPLAY INDICATIONS
9.1 Inverted display mode - Check flash
Depending on the configuration of use and the number of units, the
position of the strobes may be reversed by 180°. With this setup, the
control display is upside down, making it difficult to read.
The simultaneous pressing of the left and right lever selectors for a
long time (about one second), allows the numerical indication of the
central display to be inverted.
Regardless of the position of the strobe, the selected power or
compensation values can be read easily at any time.
The activation of the display reverse reading is signaled both by a low
power control flash and by a single beeping sound after which the
control levers must be released.
The low-power flash emission is useful for quickly checking the
operation of the strobe even without d-SRL connected.
9.2 Power output reading
In TTL auto flash exposure mode, the amount of light is dosed
automatically.
After every shot in this mode, the display shows the percentage of
power output supplied by the strobe.
In this way it is possible to vary the exposure parameters, shutter
speeds and/or apertures, in the right way, always ensuring full power
coverage of the flash.
In case the required power is greater than the maximum that can be
delivered, the display will signal Full - full power and a beeping sound
repeated will be emitted.
20