PROBLEMS - ERROR INDICATIONS - MAINTENANCE
15.0 Problem and error indications
The unit is controlled by microprocessors that allow all operation
functions to be managed intelligently, thus guaranteeing a very high
level of reliability.
The safety or protection alert of essential operational parameters as
operating temperature and battery pack discharge are indicated as
follow.
15.1 Overheating protection
If the unit internal temperature is higher than the maximum allowed
value, the fault is indicated on the display by the following safety alert:
§
EH1
The unit automatically switches to the standby mode for 20 seconds,
the safety alert flashes on the display and a beeping sound is emitted
every 2 seconds. At the end of standby time the unit automatically
switches off.
If this happens, remove the battery pack from the strobe and put the
separate units in a cool place or in a ventilated area until they are
cooled.
Do not leave the strobe in overheated environments such as car
interiors in summer or boat engine compartments. Do not expose
the strobe in summer directly to the sun for prolonged periods,
overheating can damage the unit and create dangerous situations.
36
Summary of Contents for ONE160x
