86
GB
8
Dismantling / Mounting in Case of Service
1505093, Edition 2012-05, Version 5
8.4 Mounting the end device to the ACROBAT2000 spring arm
Follow the safety instructions
Follow the general safety instructions prescribed in
“Chapter 8.1” on page 80
.
Maximum loading capacity
Calculate the maximum loading capacity as described in
“Chapter 8.2.3” on page 82
.
Figure 10: Version with 3-pole plug cou
-
pling
Preparing the installation
(See "Figure 10")
1. Unscrew the sleeve securing screw M3 x 8mm
2
and push the sleeve
1
upwards.
2. Screw the sleeve securing screw M3 x 8mm
2
back in in order to fasten the
sleeve
1
.
3. Remove the securing segment
5
using a suitable slotted screwdriver.
Only for version with 3-pole plug coupling
(See "Figure 10")
1. Grease the pivot groove and the pivot
4
using a suitable friction bearing grease
(e.g. Microgleit GP 360).
2. Position the pivot with 3-pole plug coupling
4
, keeping it straightly aligned, and
establish the assembly connection
3
by gently pushing towards the spring arm
4
.
Figure 11: Version with 5-pole plug cou
-
pling
Only for version with 5-pole plug coupling
(See "Figure 11")
1. Grease the pivot groove and the pivot
4
using a suitable friction bearing grease
(e.g. Microgleit GP 360).
NOTE – Plug positioning through the grooves
•
The 5-pole plug coupling
4
has a narrow groove
6
and a wide groove
5
.
•
To establish the plug connection
3
, the grooves
5
/
6
must fit into the corresponding
grooves of the counter piece.
2. Position the pivot with 5-pole plug coupling
4
, keeping it straightly aligned, and es
-
tablish the assembly connection
3
by gently pushing towards the spring arm
4
.
