46
Transferring Programs from the ZEN
Section 3-4
as the CPU Unit is the same type as that specified in the property
settings of the Support Software.
When going online, a confirmation message, such as the
example shown below, will be displayed. Select "Y" (yes) to
connect, and then perform the transfer operation.
"ZEN model in properties settings (10C1A*-A-V2) does not match
model being connected (10C1A*-A-V2+8E1**). Go online? Y/N"
2.
Refer to
6-2 Program Check Errors and Warnings
for information
on error messages that occur during transfer from the computer
to the ZEN.
3-4
Transferring Programs from the ZEN
This section describes how to transfer the ZEN ladder programs to
the ZEN Support Software.
The ZEN must be connected and online and the project file opened
before the program transfer operation can be executed.
1,2,3...
1.
Click the
Transfer From ZEN
Button on the Toolbar or select
ZEN(Z)/Transfer(R)/Transfer from ZEN(T)
from the Menu Bar.
The Transfer From ZEN Dialog Box will be displayed. Click the
OK
Button to transfer the program from the ZEN. Click the
Cancel
Button to cancel the transfer.
Settings Details
Select
The settings are uploaded too
in the Transfer From ZEN
Dialog Box to upload the ZEN settings at the same time.
Note
a) If a password has been set for the previously opened project
file (see
4-2 Setting a Password
), the password will be cleared,
and a comfirmation dialog box will be displayed.
b) Refer to
6-2 Program Check Errors and Warnings
for
information on error messages that occur during transfer from
the ZEN to the computer.
Z184-E1-04.book Page 46 Thursday, November 20, 2008 4:25 PM