![background image](http://html1.mh-extra.com/html/omron/sysmac-c200h/sysmac-c200h_operation-manual_742423329.webp)
Programming Console Operations
Appendix C
322
Operation/Description
Modes*
Key sequence
3-word Change
This operation changes the value of
a word displayed during a 3-word
Monitor operation. The blinking cur-
sor indicates the word that will be af-
fected by the operation. The cursor
can be moved by using the up and
down keys. When the cursor is at the
desired location, press CHG. After
entering the new data, pressing
WRITE causes the original data to be
overwritten.
P M
WRITE
CHG
3-word Monitor
in progress
[Data]
Cycle Time Display
This operation should be performed
after all syntax errors have been cor-
rected. The cycle time can only be
checked in RUN or MONITOR mode
and while the program is being ex-
ecuted. The cycle time displayed af-
ter pressing CLR and MONTR is that
for the current cycle. Pressing
MONTR again will display a new
cycle time. Any difference between
successive cycle times is due to the
different execution conditions that
exist during each cycle.
R M
CLR
MONTR
MONTR
Hex/ASCII Display Change
Converts 4-digit hexadecimal DM
data to ASCII and vice-versa.
R P M
TR
Word currently
displayed
Binary Monitor
The contents of a monitored word
can be specified to be displayed in
binary by pressing SHIFT and
MONTR after entering the word ad-
dress. Words can be scrolled by
pressing the up and down keys to in-
crement and decrement the dis-
played address. To terminate the
binary display, press CLR.
R P M
[Word address]
Binary monitor cancel
All monitor cancel
*Modes in which the given instruction is applicable: R = RUN, M = MONITOR, P = PROGRAM
Summary of Contents for SYSMAC C200H
