6-9
6-4
Overtorque Detection Function
When an excessive load is applied to the equipment, the Inverter detects the overtorque
condition through an increase in the output current.
n59
Overtorque Detection Function Selection
Changes during
operation
No
Setting
range
0 to 4
Unit of
setting
1
Default setting
0
Set Values
Value
Description
0
Inverter does not monitor overtorque.
1
Inverter monitors overtorque only when speed is matched. It continues operation (issues
warning) even after overtorque is detected.
2
Inverter monitors overtorque only when speed is matched. It discontinues operation
(through protective function) when overtorque is detected.
3
Inverter always monitors overtorque during operation. It continues operation (issues
warning) even after overtorque is detected.
4
Inverter always monitors overtorque during operation. It discontinues operation (through
protective function) when overtorque is detected.
•
Set n60 for overtorque detection level and n61 for overtorque detection time to enable the overtorque
detection function. The Inverter will detect overtorque when the current the same as or higher than the
detection level is output for the preset detection time.
•
Set n40 for multi-function output to either of the following so that external overtorque detection output
will be ON.
Set Value: 6 for overtorque detection (NO)
Set Value: 7 for overtorque detection (NC)
Overtorque Detection
Output
current
n60 (Overtorque
detection level)
Time
Overtorque
detection (NO)
n61
Overtorque detection time
Time
Note
Overtorque detection will be canceled if the output current decreases from the detection level by approxi-
mately 5% of the Inverter rated current.
See note.
n60
Overtorque Detection Level
Changes during
operation
No
Setting
range
30 to 200 (%)
Unit of
setting
1%
Default setting
160
Advanced Operation
Chapter 6
Summary of Contents for SYSDRIVE 3G3JV-A4002
