![background image](http://html1.mh-extra.com/html/omron/nt20m-series/nt20m-series_operation-manual_743774027.webp)
20
3.
Use the accessory metal fittings and tool to fasten the Terminal to the
panel surface. Do not use a screwdriver on the fittings, otherwise the
fittings or the terminal of the NT20M may become damaged.
NT20M
NT2000M
Securing the NT20M to the Panel
After setting the NT20M into the panel, secure it as shown below.
(1) First pass the plastic part of the
fitting through slot (a).
(2) Next, put the hook of the fitting
into slot (b) and pull so that the
leg catches in the NT20M case.
NT20M
Fitting
Plastic
(1)
(2)
(b)
(a)
Turn the screw with the tool that comes with the NT20M, and secure the
NT20M to the panel. When you are finished, rotate the tool in the re-
verse direction and remove it from the screw.
NT20M
Accessory tool
4.
To remove the NT20M from the panel, use a flat-blade screwdriver. (For
the NT2000M, use a Phillips screwdriver.)
4 panel installation fittings
Flat-blade screwdriver
Securing the NT2000M to the Panel
Using the tool that comes with the NT2000M, secure the NT2000M to the
panel from behind. When not making it waterproof, the four places marked
“A” in the illustration below must not be tightened. Use a tightening torque of
no more than 6 kg.
When making the NT2000M waterproof, tighten all twelve places shown in
the illustration, including the places marked “A.” Use a tightening torque of at
least 8 kg and no more than 10 kg.
Installing in a Panel
Section 2-4