60
6-3-4
Initialization
You must initialize the image data memory when using the SRAM or EE-
PROM for the first time. Initialization can also be used to clear all or part of
the data already registered in the PT.
Initializing Memory
If you select Init. Memory in Maintenance Mode, a screen will be displayed
providing a selection of data to be initialized (i.e., image data, memory table
data, or history data). After one of the choices has been selected, another
screen will be displayed to confirm that you actually want to initialize that
data.
If you select Yes, then initialization will be executed and all of the selected
data will be deleted. (If memory table data is initialized, then the values set
by the Support Tool will be restored.
6-4
Memory Switch Settings
Memory switch settings set the NT20M display and key input sounds.
Select “Memory SW” from the Maintenance Mode Menu.
MAINTENANCE MODE MENU
Display History
I/O Check
PT Settings
Initialize Memory
Select one
MemorySwitch
Quit
Liquid Crystal Display Type
Move the cursor to the item that is to be set and press the Enter Key. Each time
that it is pressed, the set value will change.
After the settings have been made, press the Buzzer, Up, and Down keys to re-
turn to RUN Mode. If the power to the NT20M is turned off at this point, the set-
tings will not be registered.
Quit
MEMORY SW MENU
Key Input Sound
ON
Backlight Off
10 min
Display
Normal
Resume Function
ON
Memory Switch Settings
Section 6-4
