![background image](http://html1.mh-extra.com/html/omron/dst1-series/dst1-series_operation-manual_743062045.webp)
2-1 General Procedure
2-1 General
Procedure
The general procedure for using the DST1-series Safety I/O Terminals is given below.
Refer to the
DeviceNet Operation Manual
(Cat.No.W267) for the network structure and
the topology.
Install the DST1-series Safety I/O
Terminals in the control panel.
↓
Wire I/O power and cables.
↓
Connect communications connectors.
↓
Set the node address.
↓
Configure the system.
Make settings for the DST1-series
Safety I/O Terminals.
Refer to
Section 3
.
The baud rate of the entire system is determined by the baud rate of the Master Unit.
The baud rate does not need to be set for each DST1-series Safety I/O Terminals.
Node adress switches
Refer to Section 2-5.
Communications
Connector
Refer to Section 2-4.
Teminalblocks
Refer to Section 2-3.
Indicators
Refer to Section 4-2.
2-2
Summary of Contents for DST1 Series
