Omron BF511, Instruction Manual

Page: 14 / 145

13
EN
6. Error Displays
7. Troubleshooting
Error Display Cause Correction
Your palms or soles are not in firm contact
with the electrodes.
Press your palms or soles firmly to the
electrodes, then measure. (Refer to Section
4.)
The posture for measurement is wrong or
the palms or soles are not in firm contact
with the electrodes.
Measure without moving the hands or soles.
(Refer to Section 4.)
The palms or soles are too dry.
Moisten the palms or soles with a wet towel,
then repeat measurement.
Values of body composition are out of
measurable range.
• Please ensure that age, gender and height
settings stored as personal data are correct.
(Refer to Setting Items in Section 9.)
• The main unit cannot measure body
composition outside its measurement range,
even if the Age, Gender and Height settings
are correct.
Abnormal operation.
Insert the batteries again and repeat
measurement.
If this error still occurs, consult your OMRON
service representative.
You stepped on the unit before the display
indicated “0.0 kg”. Step on the main unit after the display
indicates “0.0 kg”.
You moved the main unit before the
display indicated “0.0 kg”. Do not move the main unit until the display
indicates “0.0 kg”.
You moved your body while measuring
body weight.
Do not move while measuring body weight.
Your weight is 150 kg (330.0 lb) or over.
Body weight of 150 kg (330.0 lb) or over is
out of the measuring range of this unit. You
cannot use this unit.
Problem Cause Correction
The displayed value of body
composition is abnormally high or
low.
Refer to “Information on Body Composition”.
The power turns off approximately 5
minutes after the body weight is
confirmed and before your body fat
percentage, visceral fat level,
skeletal muscle percentage, BMI
and resting metabolism is
measured.
You did not select the correct
personal profile number or the
GUEST mode. (The personal profile
number or “G” is not displayed on
the display unit.)
Select the correct personal profile
number or the GUEST mode. (Refer
to Section 4.)
Nothing is displayed when the
power is turned on.
Batteries are not inserted. Insert the batteries.
The polarities of batteries are not
aligned correctly. Insert the batteries in correct
alignment.
The batteries are worn out.
Replace all four batteries with new
ones. (Refer to Section 2.)
The cord connecting the main unit
and the display unit is damaged or
worn.
Contact the nearest OMRON
service representative.
Care and maintenance
HBF-511_main.book 13 ページ ２０１２年２月３日 金曜日 午前１０時４０分