Omron B5L, User Manual, Page: 57 / 72

Chapter 4 Command Description
4-20 Set Enabling/Disabling Operation Check LED (95Hex)
3D TOF Sensor Module B5L User's Manual (No. E596)
4-20 Set Enabling/Disabling Operation Check LED (95Hex)
Enables or disables the operation check LED.
When disabled, the operation check LED cannot be lit/flashing after startup.

Command (from host to this product)
Synchroniz
ation code
Command
No.
Data length Data
FEHex 95Hex 00Hex 01Hex See below for details

Response (from this product to host)
Synchroniz
ation code
Response
code
Data length Data
FEHex Normal
end: 00Hex 00Hex 00Hex 00Hex 00Hex
Error:
FFHex to
F0Hex 00Hex 00Hex 00Hex 00Hex
・
Data details
Specify 0 to enable the operation check LED or 1 to disable it.
The default value is 0 (enable).
This product's status
Operation check LED status
Enabled
Disabled
When power is turned
ON Solid ON Solid ON
Under normal
operation Solid ON Not lit
Error occurred
*1
Flashing Not lit
The status is enabled or disabled immediately after receiving the command.
*1: A status in which this product cannot be properly started up due to an error such as a
device error.
57