![background image](http://html.mh-extra.com/html/olympus/bondmaster-600/bondmaster-600_user-manual_733846154.webp)
DMTA-10045-01EN, Rev. E, August 2016
Chapter 6
144
To calibrate the signals
1.
Press the DISP/DOTS menu key (
) once, and then set the
POSITION
(C key)
to
CENTER
.
2.
Press the ALARM menu key (
), and then set the
XY ALM 1
(B key) to
OFF
.
3.
Place the probe tip on a good part of the standard, and then press the CAL NULL
key (
).
4.
Lift the probe into the air to observe the dot’s movement; if the dot disappears off
the screen, press the GAIN key (
), and then use the knob to adjust the dot
position so that it remains on the screen (see Figure 6-31 on page 144).
Figure 6
‑
31 Adjusting the dot position
5.
Place the probe tip on a good part of the standard, and then press the CAL NULL
key (
).
6.
Slowly scan over a disbond and a repaired area, and then press the FREEZE key
(
) [see Figure 6-32 on page 145].
Summary of Contents for BondMaster 600
