![background image](http://html.mh-extra.com/html/olympus/bondmaster-600/bondmaster-600_user-manual_733846085.webp)
DMTA-10045-01EN, Rev. E, August 2016
Control Functions
75
Changing Parameters in the PC (RF) Main Menu
The following information is applicable when the BondMaster 600 mode is set to PC
(RF) and the MAIN menu key (
) has been pressed.
FREQ
(frequency)
The
FREQ
(frequency) setting determines the frequency of the tone burst. This is
adjustable from 1 kHz to 50 kHz.
To change the
FREQ
setting, press the A key, and then rotate the knob to the
desired frequency.
Press the Enter key (
) once, while the
FREQ
parameter is highlighted, to enable
the fine knob function, which decreases the frequency selection increments from 1.0
(coarse) to 0.1 (fine) increments. By default, the knob adjustment is set to coarse
increments, and
FREQ
is underlined when the coarse knob function is enabled. To
turn the coarse knob function back on, press
one more time.
RF GAIN
The
RF GAIN
, or vertical gain, setting controls the gain of the tone burst signal.
This is adjustable from 0.0 dB to 70.0 dB.
The
RF GAIN
is the master gain setting, and it should be always be adjusted first
when a gain change is desired.
To change the
RF GAIN
setting, press the B key, and then rotate the knob to the
desired gain value.
WIDTH
The
WIDTH
setting controls the amount of time displayed after the beginning of
the tone burst that is displayed on the Y (amplitude) versus T (time display).
To change the
WIDTH
setting, press the C key, and then rotate the knob to the
desired width value.
NOTE
TIP
Summary of Contents for BondMaster 600
