Olivetti d-Copia 5200MF, Service Manual

Page: 87 / 502

2KR/2KS
1-3-50
U144
Setting toner loading operation
Description
Sets toner loading operation after completion of copying.
Purpose
To set whether or not toner is loaded on the drum after low density copying. Normally no change is necessary
from the initial setting.
Setting
1. Press the start key.
2. Select the item to be set.
Initial setting: MODE2
3. Press the start key. The setting is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
U155
Checking sensors for toner
Description
Displays the on-off status of each sensor or switch related to toner.
Purpose
To check if the sensors and switches operate correctly.
Method
1. Press the start key.
2. Turn each switch on and off manually to check the status.
When the on-status of a switch is detected, that switch is displayed in reverse.
3. To stop motor driving, press [MOTOR ON] again.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description
MODE0 Toner not loaded
MODE1 Toner loaded after simplex or duplex copying
MODE2 Toner loaded after simplex copying
Display Switches and sensors
DEVELOPER SENSOR Toner sensor (TNS)
CONTAINER SET Toner container detection switch (TCDSW)
CONTAINER SENSOR Toner container sensor (TCS)
DISPOSAL TANK SET Waste toner detection switch (WTDSW)
DISPOSAL TANK SENSOR Overflow sensor (OFS)
MOTOR The toner feed solenoid (TNFSOL) and the paper feed motor
(PFM) are turned on.
Service Manual Y111 960 - 2