Oliver 4065, Owner'S Manual, Page: 58 / 88

58 |
Page Oliver Machinery 4065 Table Saw
Belt Replacement
1. Disconnect the saw from the power source.
2. Remove the motor access panel.
3. Slightly loosen the four motor mounting nuts
so the motor can be temporarily raised to
the highest position. Retighten the nuts.
4. Remove the belt by walking the belt off the
arbor pulley and then sliding the belt
through the gap between the motor pulley
and the elevation bracket (#32 in the parts
diagram).
5. Install the new belt. First, slide the belt
through the gap between the motor pulley
and the elevation bracket, then walk the belt
and make sure it sits correctly on the motor
pulley and arbor pulley.
6. Loosen the motor mounting nuts to tighten
the belt, then retighten the nuts to secure
the motor.
7. Reinstall the motor access panel to complete
the process.
IMPORTANT
Do not over tighten the belt, as it can accelerate wear and tear of the belt and
the bearings.