Oliver 4065, Owner'S Manual, Page: 28 / 88

28 |
Page Oliver Machinery 4065 Table Saw
10. Gather the mounting hardware that comes
with the extension table package and the
remaining fasteners for rail installation.
11. Thread the entire length of the leveling feet
(#5) into the table legs (#4).
12. Insert the flat washer (#7) into the M10 bolt
(#6). There are three sets of these fasteners.
Thread them on the right side of the saw
table. Leave a gap between the washer and
the table for hanging the extension table
frame.
13. With the help of two other people, hang the
frame of the extension table onto the M10
bolt. Make sure the frame sits in between
the table and the flat washer.
14. Insert the flat head hex screws (#16) through
the front rail screw holes. On the other end
of the screw, insert the M8 spring washer
(#20), M8 flat washers(#22) and hand
tighten the M8 nuts (#19).
15. Insert the M8 spring washer (#20), M8 flat
washer (#22) into the cap screw (#17), and
then insert that into the rear rail screw holes.
On the other end of the screw, insert the flat
washers (#22) and hand tighten the M8 nuts
(#19).
16. At this point, the extension table is loosely
mounted. Mount the extension legs onto the
extension table frame. Insert the spring
washers (#21) and flat washers (#23) into the
eight M6 hex bolts (#18) available, then
thread them through the table frame’s
screw holes and into the tapped screw holes
on the leg. Tighten all bolts.
17. Remove the protective film of the extension
table.
18. Adjust the height of the extension table. Use
a long straight edge to ensure the extension
table runs flush and coplanar with the cast
iron table, then tighten all fasteners to
secure the extension table.