Oliver 4065, Owner'S Manual, Page: 52 / 88

52 |
Page Oliver Machinery 4065 Table Saw
Blade Tilt Angle Pointer Adjustment
The blade tilt angle pointer was calibrated at the
factory and should not need further adjustments.
If the pointer has shifted, it can be adjusted.
1. Disconnect the saw from the power source.
2. Set the blade angle to 90 ° with a digital
protractor or a machinist square.
3. Locate the screw that holds the pointer in
place. It is behind the blade height
handwheel.
4. Loosen the screw, adjust the pointer, then
retighten the screw.
5. This is also a good time to reset the reading
of the blade tilt angle value on the digital
readout. Long press the “Set 0” button to
zero the reading.
Blade Angle Positive Stops Adjustments
There are two positive stops for setting the blade
tilt angle at 0
°
and 45
°
. These positive stops are
calibrated at the factory and should not require
further adjustments. Please follow these steps In
case adjustments are needed.
1. Disconnect the saw from the power source.
2. The 0 ° positive stop bolt is located behind
the motor access panel. Remove the motor
access panel.
3. The 0 ° positive stop bolt can be found on top
of the gear block (#77 in the parts diagram),
and it’s secured by the jam nut.
4. To adjust the stop bolt, adjust the blade
angle so the stop bolt is not in contact with
the trunnion bracket (#84 in the parts
diagram), then loosen the jam nut. Adjust
the stop bolt until it stops the trunnion when
the blade is perpendicular to the table, then
lock the stop bolt with the jam nut.