Oliver 4065, Owner'S Manual, Page: 51 / 88

4065 Table Saw OLIVERMACHINERY.NET
51 |
Page
Fence Scale Adjustment
The fence scale should be adjusted if the width-
of-cut it indicates does not match the actual cut
width.
1. Prepare a piece of scrap plywood with a
straight edge for ripping. The scrap piece
should be approximately 13” wide and 24”
long.
2. Reposition the fence to set the width-of-cut
to 12”.
3. Follow the safety guidelines and the
procedures in “Making a Rip Cut” on page 41
to make the rip cut.
4. Measure the new width of the scrap piece.
5. To adjust the indicator, loosen the screws
that hold the indicator in place, reposition
the indicator, and then retighten the screws.
Miter Gauge Angle Indicator Adjustment
If the miter angle indicator has shifted and does
not indicate the correct angle, it can be adjusted.
1.
Disconnect the saw from the power source.
2. Use a square to set the miter angle to 90 °
against the blade. Tighten the handle to lock
the miter gauge.
3. Loosen the screw that holds the indicator in
place.
4. Adjust the indicator and tighten the
mounting screw.